RHEEM "Scratch & Dent" Commercial Central Air Conditioner 5 Ton Package RJPLC060CL000 ACC-6808

"Scratch & Dent" 5 Ton Central Air Conditioner Commercial Package Unit RHEEM Model RJPLC060CL000 ACC-6808

New, "Out of Box". Manufacturer's Warranty Available. Commercial Unit, requires 208/230 Volt-3 Phase Electrical

• Rheem
• RJPL-C060CL000
• 5 Ton
• 14 SEER
• Heat Pump Unit
• Clear Control
• 208-230 V, 3 Ph, 60 Hz,
• R410A
• *Unit is fully charged with refrigerant

Specification Sheet

Features:

• R-410A HFC refrigerant.
• Complete factory charged, wired and run tested.
• Scroll compressors with internal line break overload and high pressure protection.
• Single stage compressor on all models.
• Convertible airflow.
• TXV refrigerant metering system on each circuit.
• High Pressure protection standard on all models. Low Pressure/Loss of charge protection standard on all models.
• Solid Core liquid line filter drier on each circuit.
• Single slab, single pass designed evaporator coil facilitate easy cleaning for maintained high efficiencies.
• Cooling operation up to 125° F ambient.
• Easy access to filter, blower, electric heat, and compressor/control compartments permit prompt service.
• Powder Paint Finish meets ASTMB117 steel coated on each side for maximum protection. G90 galvanized.
• One piece top cover and one piece base pan with drawn supply and return opening for superior water management.
• Externally mounted refrigerant gauge ports for easy service diagnostics.
• Easy to install plug-in; slip in, 100% fully modulating economizer with barometric relief.
• Forkable base rails for easy handling and lifting.
• Single point electrical connection.
• High performance belt drive motor with variable pitch pulleys and quick adjust belt system.
• Permanently lubricated evaporator and condenser motors.
• Condenser motors are internally protected, totally enclosed with shaft down design.
• 1" filter standard with slide out design.
• Colored and labeled wiring.
• Copper tube/Aluminum Fin coils.
• Molded compressor plug.
• Supplemental electric heat provides 100% efficient heating.
• Factory installed ClearControl™, a Direct Digital Control (DDC)and sensors which can connect to LonWorks™ or BACnet BAS systems for remote monitoring and control.